www.flightsim4fun.com - rksoftware

Hi

I had done everything above correctly except for the details above in the script.....inexperience.....The script works perfectly, gread job. I apologize and thank you for patience.

Many many thanks .
Chaidaris ( LGAV ).

Hi

First of all I Wishing you a Happy New Year

I made many attempts , but without success .I wonder if I did something wrong, but I even wrote it by hand.any idea ?

Thank you.

Hi

Thank you very much for the response.The overheade ia my own construction.The wipers are norrmaly connected with 4 contacts per wiper.The numbers are : Left wiper..Park = 76 / int = 77 / Low = 78 / High = 79 Right wiper...Park = 72 / Int =73 / Low = 74 / High = 75 .

Thank you .

Hi

I followed your advice and everything works fine.Another problem is that the wipers keep the same speed in all positions .Is there a solution to this?

Thank you ,I Wishing you a Happy New Year.

Hi I have a problem with the servos on the overhead .Until now I was using the OCP4NGXv 5.5 and everything worked normally. Recently I switch to Oi4FS24 .The question is about the overhead servos ,where I use 2 servo cards[37/38],so in one I have APU,FT,VSI and in the other ENG1/2,PRESS L/R. Now in ...

Thank you very much ,the problem is solved.

Hi I have a strange problem with the module "LE FLAPS" on overhead AFT .The left led s [11-26] light up normally but the right ones [27-42] do not. With the SIOC monitor everything is OK, even with the test button on the module. The numbers seem to be in the correct position .All modules a...

Hi
You are right. That was my omission indeed. My apologies.

Thank you.

Hello After my computer crashed, on new computer i installed the SIOC 703B2 and OC4BAv5 (by book), but no lack. When i attempt to configure the OC4BAv5 it presents this :Unhandled exception has occur in your application , if you click Continue the application will....... [Could not find file \PMDG73...

Hi Roar My Overhead works fine,except the start switch 1(L).Looks like it is permanently in the free position (OFF)? Settings via the SIOC monitor are done properly. Start switch 2 (R) works fine.Any ideas? As per the symbol"//", when i put it in front of this, is OK. //Var 2592 name bATTE...